Barrel type shot blasting machine trail run and pre-assemble in workshop

We had a set of barrel type shot blasting machine trail run and pre-assemble in our workshop. The machine is ordered by an American customer. They use the machine to blast some not easy to collide workpiece. In order to facilitate customer installation, we trail run the machine and make more videos for the customer before delivery.

The barrel type shot blasting machine is the machine that used the high-speed rotating of the impeller under the centrifugal force to project the steel shot to the surface of the workpiece, to achieve the cleaning effect. It can be used to clean up easily overturned workpieces, non-brittle parts that are not easy to collide, castings and forgings with not deep cores, and welding parts, and to remove grit and oxide scale on the surface of the workpiece. The whole machine adopts PLC control, which has a high degree of automation, which can be used as a stand-alone machine or by wiring. It is suitable for sand cleaning, rust removal, descaling, and surface strengthening of castings and forgings under 15kg in various industries.

Barrel type shot blasting machine trail run and pre-assemble in workshop 2

The structural characteristics of the barrel type shot blasting machine:

  1. It adopts a drum design and is equipped with high-efficiency blast turbines. During the shooting process of steel shots, the drum can not only rotate but also shake up and down, so that the workpieces in the barrel can be completely stirred without impact, and the effect of uniform cleaning can be achieved. high working efficiency.
  2. It can clean general castings and forgings, and can also handle thin-walled parts, small and special workpieces that are easy to jam.
  3. The roller structure adopts hydraulic control, the equipment working process is stable and the positioning is accurate.
  4. The maintenance is simple, and the structure of the drum and the body is simple, so it can reduce the wearing parts and save the time and cost of maintenance.

Barrel type shot blasting machine trail run and pre-assemble in workshop 1

The sealing problem of the barrel type shot blasting machine

The sealing problem of the shot blasting machine solves the problem of dust around the door when the door is opened. A new fully sealed structure is adopted to prevent projectiles or dust from escaping from the sealing groove on the top of the equipment. A spring clamp steel rubber plate is designed inside the door of the equipment. The top of the equipment adopts a fully sealed structure, and dust can only escape from the door of the equipment. Therefore, as long as the dust removal port is set at the entrance and exit of the equipment, the problem of dust escape can be solved well. Dust will be easy when the door is opened The ground is sucked away. Avoid the entrance of the door or the dust on the top caused by the dust suction port on the top of the previous care. The anti-reverse device of the bucket elevator is to prevent the bucket elevator from encountering a sudden power failure or unexpected shutdown The bucket elevator’s lifting belt reversal causes damage to the equipment, and the bucket lifting belt is designed with an anti-reversal device.

0 replies

Leave a Reply

Want to join the discussion?
Feel free to contribute!

Leave a Reply

Your email address will not be published. Required fields are marked *