Cylinder diabolo shot blasting machine

Cylinder shot blasting machine is mainly used to clean the surface of the surface of steel cylinders of various diameters. It can apply strong shot blasting to the surface of the steel in the original state to remove the rust and rust layer and its oxide scale on it to obtain a certain degree smooth finish, uniform metallic luster surface, in order to remove stress, improve the surface coating quality and corrosion resistance of steel.

The cylinder shot blasting machine is a  conveyor through shot blasting equipment, which consists of a loading feeding mechanism, a feeding roller conveyor, the blast turbine, a feeding roller conveyor, a unloading feeding mechanism, an air control system, an electric control system and a dust removal system. The shot blasting machine is composed of shot blasting chamber, shot blasting turbines assembly, blasting pipe and grid, blasting slag separator, bucket elevator, platform ladder railing, abrasive supply system and other components. Most of the weldments of this machine are shot and shot blasted to improve the anti-rust performance and paint film adhesion.

Cylinder diabolo shot blasting machine 1

  1. Into (out) roller conveyor

The into and out feeding roller conveyor is responsible for sending the workpiece into and out of the blasting chamber for cleaning. The into and out feeding roller conveyor is arranged at an inclination, and the workpiece rolls into the cleaning station by its own acceleration based on the initial acceleration.

  1. Workpiece turning mechanism

The workpiece turning mechanism turns the workpiece from the rotation state to the rolling state. The power for turning the workpiece comes from the cylinder.

  1. Workpiece rotation mechanism

When the workpiece rolls from the slide into the cleaning station, it enters the cleaning state. At this time, the workpiece is supported by two rollers and is rotated by the rollers (by friction).

This machine is a high-function continuous operation cleaning with continuous feeding. During the cleaning process, the electromagnetic speed-regulated conveying roller is controlled by the electricity to send the steel cylinder into the ejection zone of the cleaning machine room. All sides of its body are affected by four different coordinate positions. The impact and friction of the powerful and dense projectiles caused the oxidized rust layer and its dirt to fall off quickly, and the surface of the steel cylinder obtained a bright surface with a certain roughness. The falling projectiles and rust dust are transported to the abrasive recycle system by the recovery screw. Load and unload workpieces on both sides of the roller conveyor outside the blasting chamber. During the cleaning process, the sprinkled pellet dust mixture is collected in the lower part of the elevator through the chamber funnel and the longitudinal and crosswise screw conveyor, and then lifted to the separator on the upper part of the machine. The separated pure steel shots fall into the separator hopper. Dust generated in shot blasting is sent to the dust removal system by the exhaust pipe, and the purified gas is discharged into the atmosphere. The granular dust is sent to the dust removal system by the exhaust pipe, and the purified gas is discharged into the atmosphere. The granular dust is captured and collected.

Cylinder diabolo shot blasting machine 2

0 replies

Leave a Reply

Want to join the discussion?
Feel free to contribute!

Leave a Reply

Your email address will not be published. Required fields are marked *