How to maintain shot blasting machine

How to maintain shot blasting machine

The shot blasting machine is mainly used for removing oxide coating, welding slag and dust, which can increase the adhesion of coating. So the shot blasting machine need to maintain after used. To maintain the shot blasting machine need to attention some points:

  1. The machine should be check before start to work every day.
  2. We should regularly check the wear of the guard plate, the control cage of the shot blasting machine and the pellet wheel in the blast chamber. If there is a serious wear it should be replaced immediately.
  3. Before start to work, all moving parts must be lubricated. The bearing on the spindle of the shot blasting machine need to maintain once a week. Screw conveyor and the elevator bearing need to maintain every month. The parts of the chain need to maintain every week and the motor need to be lubricated regularly.
  4. Inspect driving parts, clean parts and replace worn parts regularly.
  5. The guard plate in the blasting chamber need to according to the degree of wear to be change. When replaced the installation clearance should be controlled within 1.5mm.
  6. After the machine worked for 48 hours to check the fan and remove dust from the sub wheel, to make sure that the fan smooth operation and service life.
  7. When the machine is be checked and repaired the motor must be cut off to avoid accident.

How to maintain shot blasting machine1

How to maintain shot blasting machine2

If you want to know more details about the shot blasting machine and sandblasting room please do not hesitate to contact us.

 

0 replies

Leave a Reply

Want to join the discussion?
Feel free to contribute!

Leave a Reply

Your email address will not be published. Required fields are marked *